4we10 rexroth hydraulic Valves
Standard flow of 4WE10 bosch rexroth hydraulic Valves is 120l/m,and working pressure of hydraulic direction valve is 32Mpa,the same as NG5 valve and Cetop5 valve.4we10 rexroth type directional valve usually used on hydraulic power,hydraulic work system and industrial hydraulic equipment.
4/3, 4/2 directional valve with wet-pin DC or AC voltage solenoids
Size 4WE10 has Hydraulic Solenoid Valve
Component series has 3X (30~39),4X (40~49)
The maximum operating pressure is 315 bar
The maximum flow is 120 l/min
Ordering code
Spool symbols
1)Example:
Spool symbol E with spool position “a”, ordering code ..EA..
Performance limits(measured with HLP46 θoil = 40℃±5℃ [104℉±9℉])
Attention!
The specified switching performance limits are valid for operation with two directions of flow(e.g. from P to A and simultaneous return flow from B to T).
Due to the flow forces acting within the 4WE10 bosch rexroth valves,the permissible switching performance limits may be considerably lower with only one direction of flow(e.g. from P to A while port B is blocked)!
In such cases, please contact us!
The switching performance limit was establised while the solenoids were at operating temperature, at 10% undervoltage and without tank pre-loading.
4WE10-AC-B Outline and installation dimensions
4WE10-AC-H Outline and installation dimensions
4WE10-DC-B Outline and installation dimensions
4WE10-DC-H Outline and installation dimensions
4WE10 Rexroth hydraulic solenoid valve Related Article – Working principle of hydraulic solenoid valve
4WE10 bosch rexroth hydraulic solenoid valve is a kind of automatic basic components which used to control the flow, belonging to the actuator.Directional hydraulic control valve used to control the direction of hydraulic flow, the plant’s mechanical devices are generally controlled by hydraulic cylinder, so it will be used in directional hydraulic control valve.
The 4WE10 Rexroth hydraulic solenoid valve has a closed cavity, in which the different position of the hole, each hole connecting different tubing.The middle of the cavity is the piston, the two sides are two magnets, which the magnet coil on the body will be attracted to the side, through the directional hydraulic valve to open or close the directional hydraulic control valve to open different oil drain hole.And into the hole is open, the hydraulic oil will enter a different row of tubing, and then through the pressure to promote the piston, the piston and the piston rod, the piston rod drives the mechanical device.Thus through the current control of an electromagnet to control the mechanical movement.